In the process of using the edge banding machine, the edge sealing product shall not have the phenomenon of opening the rubber, missing the head, leaking the seal, stacking the seal, deviation, and indentation. The glue shall be tight and the surface shall be smooth and clean.

During the work process, it is necessary to pay attention to clean the waste glue, broken edge strips and other debris in the rubber furnace to make the return flow smooth. The operation should be handled gently and gently, and the surface of the board should be removed to protect the board from wear. The parts completed by the edge sealing shall be inspected with the quality inspector, and the qualified parts shall be piled up neatly, attached with the processing flow and sent to the next process, and the unqualified parts shall be repaired in time.

Power outages and other accidents occur during operation. When leaving the operation position, the power should be turned off. Before the equipment is shut down, the electric heating tank should be turned off, and the glue and scorched residual glue on the rubber furnace, as well as the glue on the rubber roller and the fixed rubber roller, and the glue of the two rubber rollers should be removed. Volume is adjusted to a minimum of zero.

In the process of furniture edge sealing, sometimes the edge banding machine will be unevenly coated, then how to solve it at this time:

1. First try to increase the glue of the semi-automatic edge banding machine (for the large angle of the door), if you can not open the plastic box cover to see if the glue is or not, if the glue is too thick, please raise the temperature. If the temperature has been adjusted to the highest value of the glue used, it is the poor quality of the glue, please replace it with other brand glue.

2. If the glue is not sticky, then check if the plate is tight. Qingdao Ocean Precision Woodworking Machinery Factory reminds that if the plate has been pressed, the back half of the plate is still not glued, and the rubber box top wire (without spring) inside the rubber cover of the rubber box can be adjusted, and the loose hexagonal screw rod (do not adjust too much) , loosen 0.5 to 1.5 laps as needed.