The main advantage of the curved edge banding machine is that the bonding is firm, fast, light and efficient. In addition to the good edge banding machine, the edge banding, hot melt adhesive, substrate, working environment should be paid attention to. And other methods such as operation methods. Select the edge band to pay attention to the width, thickness, material, toughness, surface treatment and other factors. Hot melt adhesives should pay attention to the difference between high, medium and low temperature adhesives, and match the types of edge banding. It is also necessary to scientifically set the temperature to control the temperature and the flowability and solidification delay of the sol. The selection of the substrate also has the requirements of mass, temperature, parallelism and perpendicularity of the cutting surface. The indoor temperature and dust concentration of the working environment also need to be considered, the speed of the substrate, the edge banding, the speed of the rubber shaft, the pressure, the balance, Coherence, etc. will affect the edge-sealing effect.

How to repair the curved edge banding machine There are some problems and malfunctions in the use of the curved edge banding machine. Common faults are:

1. Electrical failure. Including the host stop, the temperature is not fast, the program is disordered, etc., if not eliminated in time, it will burn the motor and the heating tube, and even damage the entire mechanical system. Mainly check the electrical control box, motor, heating tube, delay device, etc. during maintenance. This type of overhaul is usually repaired by a professional or by a manufacturer's manufacturer.

2. The gas path is faulty. Including gas valve failure, air leakage, low air pressure, cutting knife, feeding does not work, etc., mainly to check the integrity of various pneumatic components. Replacement parts can be carried out under the guidance of the manufacturer's technical staff.

3. Mechanical failure. There are mainly transmission failures, uneven feeding failure and cutter failure, etc., mainly checking the integrity of each mechanical component and whether the transmission part of the solid part is offset.

4. Bonding failure. Such as sticking, deviation, entrainment, etc., this is a comprehensive fault related to the rubber shaft, edge band, sol, substrate and operation. Such failures may occur alternately or may occur in a single operation depending on the situation.