The edge banding machine will inevitably have some troubles in our use, but how should we solve these problems? The following artisan electromechanical summarizes the problem of the edge banding machine problem.

Mainly talked about four fault aspects:

 First, the mechanical failure problem mainly shows that the edge banding machine fails to drive, the cutter is faulty, and the glue is uneven. For this type of phenomenon, we have to check that the various parts of the machine are in good condition and that its solid parts are loose. There is no deviation in the transmission part.

Second, the electrical fault problem mainly shows that the host stops, the program is confusing, the temperature rises slowly, etc., if this fault is not handled immediately, it will cause damage to the heating pipe and the motor. If it is serious, it will cause its entire mechanical damage. When we find these situations, we first check the motor, heating pipe, electrical control box, etc., pay attention to check these must be arranged for professionals, non-professionals do not operate.

Third, the problem of bonding failure is mainly manifested in the phenomenon of deviation, stickiness, etc. If it is related to the edge band, sol, rubber shaft and operation, the occurrence of such failure may be single or alternating. of. This phenomenon will wait for a professional to be dealt with immediately.

Fourth, the main problem of the gas path is that the feeding does not work, the air pressure is low, the air leaks, and the valve is not working. These phenomena we have to check the pneumatic components for damage, if you need to replace them, please ask the professional to repair.

The above four aspects are a classification of the fault phenomenon that occurs in the edge banding machine. According to these situations, we can prepare the judgment problem and immediately deal with it according to the implementation situation. Better maintain our equipment. Better improve production efficiency.